1. On your desired wall surface mark 128cm (50 in) from the floor using a measuring tape and a marker pen.
2. Line the bottom of the bracket up with the 128cm (50 in) mark that was just made and check that it is level using a spirit level.
3. Using a marker/pen, mark the holes that will need to be drilled to secure the Vision Box bracket.
4. Then, using a power drill, drill guiding holes for the wall plugs.
5. Using a hammer insert the wall plugs into the holes you have just drilled.
6. Screw the bracket onto the wall. For uneven surfaces it is recommended to place a washer between the wall and the bracket.
7. Connect the power cable into the back of the Control Box and lift the Control Box onto the bracket.
To put the Control Box on the wall, the two pins on the back of the case must slide into the slots on the wall bracket.
8. Make sure that the bracket is fully covered by the case, that the bottom of the bracket is not sticking out, and the power cable is in the slot.
9. Secure the Vision Control Box on to the Bracket with the 2 locking screws provided